One component of the ice maker assembly might be defective.
Frigidaire ice maker will not dump ice.
O normally open and when cold from the ice in the mold it will close which tells the motor to dump the ice.
Since many of the ice maker components are not sold separately you may need to purchase and replace the entire ice maker assembly.
If you ve chosen cubes but get crushed ice instead there s no need to.
We have had the water valve replaced and the air humidifier replace and the ice maker unit.
The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft.
It is getting the water and it freezes but will not dump the ice.
Certain ice dispensers built into the freezer compartment of your refrigerator offer the option of crushed or cubed ice.
Use a multimeter and check the ice maker mold thermostat ice maker mold heater and the ice maker module for faults to see if this is causing the ice cubes to not drop.
The ice bucket auger is located in the ice bin and when the dispenser is activated will rotate to pull the ice forward to the outlet chute of the bin.
This heating element may be burnt out.
This thermostat is n.
My icemaker will not dump the ice.
If this arm is in the raised position it will not make or dump additional ice.
The water despenser works great and water is getting to the icemaker too.
I have a frigidaire refigerator that is 8 years old and the ice maker is not working.
The gear box turns very slowly but has lots of power to push the ice.
I can initiate the dump sequence and it will process the ice out but it will not do it.
Some ice makers heat a little so they can release the ice to dump.
I just replaced the icemaker with a new one.
Before replacing the ice maker assembly check the water inlet valve water line and fan.
If none of these parts are at fault and the freezer.
Whirlpool refrigerator model gz25fsrxyy2 our ice maker is no longer dumping the ice it makes i think the ice maker mold thermostat may need to be replaced.
I also changed the water filter.
