Garage Door Wall Console Not Working

If the wall control doesn t light up and work properly then the wall control or the logic board in the garage door opener is defective.

Garage door wall console not working.

If the lamp works in the outlet. Diagnosing this type of wall control is more complicated than the single led type. The location of the switch will depend on the model of the device. If pressing the button on your garage door s remote control doesn t work check the batteries first.

If you remove the two wire leads and touch them together does the door open close. Check that the wires are secure by gently tugging on them. Plug a lamp into the wall outlet that services the console to check the power. Follow the leads from the switch to the motor and check for any signs of breaks pinches or shorts.

Simple but true the remote transmitter needs power to send a signal to your opener. To know for sure what the problem is you may want to have a service technician check the garage door opener. If the led isn t lit i don t think your getting power to the wall switch which is consistent with it not working. Check the console lock switch.

The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors. The transmitters remotes will not work to close the garage door. Turn off the sure lock aka vacation mode on the wall console check if limits are properly set check the door balance condition and door spring check opening force control or force settings. If so you re wall switch is bad.

You will find that the door will only move an inch or so in the close direction and reverse. Bad wiring or button.