Gas Hot Water Heater Thermocouple Replacement

If you have a gas water heater with a pilot light that won t stay lit it s probably due to a failed thermocouple.

Gas hot water heater thermocouple replacement.

Replace the two piece wire connector onto the thermocouple and igniter wire securing it with the retainer clip and slide the manifold burner assembly back into the water heater. Remove the burner assembly and detach the thermocouple. How to replace a thermocouple on a water heater. The thermocouple is a special sensing tube on gas water heaters that senses when the pilot light has flame and shuts off the gas to the unit when the pilot has been extinguished.

The gas water heater thermocouple is the safety element that is designed to inform a gas control valve is the pilot flame on or off and open or close the gas to the main burner. Learn how to replace this inexpensive part and keep your hot water heater working for years to come. Once the pilot feed pipes burner feed pipes and thermocouple are disconnected from the gas control valve simply lift the burner assembly from the bottom of the water heater and remove it. Mi403s8fbnh amazon links 24 honeywell thermocouple https gen.

Thermocouple repair replacement. In simple terms it s a short piece of tubing that runs from the gas controller to the pilot. Step 8 reattach the manifold tube pilot tube and thermocouple to the gas control valve thermostat and tighten them using the adjustable wrench. Type k chromel alumel are the most widely used general purpose thermocouple 200 c to 1350 c 330 f to 2460 f.

The thermocouple is part of the pilot assembly where one end is always in contact with the pilot flame while the other side is connected to the gas control valve. Example tank is a bradford white. Spare pilot water heater replacement thermocouple for old water heaters with foot indicators it is very simple to disassemble and replace the thermocouple. 1 cause of pilot lights that won t stay lit is a worn out.

A hot water heater that doesn t heat might just need a new thermocouple. By james carey morris carey. A thermocouple or flame sensor is a device used to control gas flow in gas water heaters on older style heaters with standing pilot lights the device is typically called a thermocouple while on newer units with electronic ignition the same or virtually the same device is called a flame sensor for our purposes we ll refer to both devices as the thermocouple.